ONE installation guide
This installation guide outlines how to install the ONE in your vehicle.
Ensure that the installation of the ONE does not interfere or inhibit normal usage of the vehicle and its safety features.
The general terms and conditions of Driver Bubble B.V. and the product disclaimer apply and are both easily electronically accessible here.
Unscrew the screws from the white mount and remove the tightening block.
Fix the mount to the driver headrest using the tightening block and the three screws. Make sure that you attach the mount so that the tightening block is on the front side of the vehicle.
Place the ONE screen against the mounting block and wrap it around the driver seat. Fix the screen in place using the screws provided. There are extra pre-drilled holes to adjust the height of the screen. Make sure to also tighten on the corner of the mount.
Secure the top front edge of the screen by threading the end of the rope through the hole in the corner of the screen and looping it around the front passenger sun visor. Tighten the rope by using the drawstring stopper.
Attach the plastic strip around the outer edge of the screen.