Shield installation guide
This installation guide outlines how to install the Shield in your vehicle.
Notes
Ensure that the installation of the Shield does not interfere or inhibit normal usage of the vehicle and its safety features.
Product disclaimer
The general terms and conditions of Driver Bubble B.V. and the product disclaimer apply and are both easily electronically accessible here.
Installation guide
Step 1
Adjust the front passenger seat’s position and backrest so that it is aligned with the front driver seat.
Step 2
You will find four reusable cable ties (2 for each front headrest). Before mounting the shield, start by threading the first cable tie through one of the pre-drilled holes, then thread the second cable tie. Make sure to thread the second cable tie in the opposite direction as the first. Now, repeat this on the other side of the Shield for the other headrest.
Next, hold the Shield up to the roof by using the back of the seats as support and tie the two cable ties to each other. Please ensure that you are using the right pre-drilled holes so that the top of the shield is aligned with the roof.
Step 3
Use one of the two velcro straps on each side of the Shield to attach the lower part of the Shield to the front seats. Take one of the velcros and thread it through the most suitable pre-drilled hole and attach the velcro together on the front side of the front seats. Repeat these steps on the other side of the Shield using the remaining velcro strap.